ZyXEL Communications Wireless Gateway Series Manual De Usuario
ZyAIR Wireless Gateway Series User’s Guide
19-6
LAN Setup
Table 19-3 Menu 3.2.1 IP Alias Setup
FIELD DESCRIPTION EXAMPLE
IP Alias
Choose Yes to configure the LAN network for the ZyAIR.
Yes
IP Address
Enter the IP address of your ZyAIR in dotted decimal notation
192.168.1.1
IP Subnet Mask Your ZyAIR will automatically calculate the subnet mask based on the
IP address that you assign. Unless you are implementing subnetting,
use the subnet mask computed by the ZyAIR
use the subnet mask computed by the ZyAIR
255.255.255.0
RIP Direction
Press [
SPACE BAR
] to select the RIP direction. Choices are None,
Both, In Only or Out Only.
None
Version
Press [
SPACE BAR]
to select the RIP version. Choices are RIP-1,
RIP-2B or RIP-2M.
RIP-1
Incoming
Protocol Filters
Protocol Filters
Enter the filter set(s) you wish to apply to the incoming traffic between
this node and the ZyAIR.
this node and the ZyAIR.
Outgoing
Protocol Filters
Protocol Filters
Enter the filter set(s) you wish to apply to the outgoing traffic between
this node and the ZyAIR.
this node and the ZyAIR.
When you have completed this menu, press [
ENTER
] at the prompt “Press ENTER to Confirm…” to save
your configuration, or press [
ESC
] at any time to cancel.
19.4 Wireless LAN Setup
Use menu 3.5 to set up your ZyAIR as the wireless access point. To edit menu 3.5, enter 3 from the main
menu to display Menu 3 – LAN Setup. When menu 3 appears, press 5 and then press [ENTER] to display
Menu 3.5 – Wireless LAN Setup as shown next.
menu to display Menu 3 – LAN Setup. When menu 3 appears, press 5 and then press [ENTER] to display
Menu 3.5 – Wireless LAN Setup as shown next.