Carrier Access Access Navigator Manual De Usuario

1. Open package containing alarm output connector (see Figure 6-15).

Figure 6-16 shows the alarm output connector wiring to a typical alarm interface 

circuit. The alarm relay output provides normally open contacts. There is no voltage 
present on these contacts until they are energized by the external alarm system.

2. Refer Figure 6-16 and Figure 6-17 when wiring connector to facility alarm system.

3. Use volt-ohm meter to ensure that no voltage is present on any of the wires going to the facility 

alarm system (see Figure 6-16).

4. Strip the wires so that 5/16 inch of bare wire is exposed (see Figure 6-17).

5. Orient the alarm output connector as shown in Figure 6-17.

6. Insert wire into top opening, then tighten screw below to clamp wire in place. 

7. Ensure that no bare wire shows after the wires are installed.

Set screws

may be on

front or bottom