Black Box EncrypTight Enforcement Point (ETEP) Manual De Usuario
Installation
50
ETEP Installation Guide
1 ET10000A chassis
•
Firmware and software is factory-installed on the unit.
2 Accessory Kit
•
Rack mount kit includes 2 mounting brackets, 16 small black screws, and 4 large silver screws
(#10-32)
(#10-32)
•
(2) Power cables (US)
•
(1) Shielded null modem cable with an RJ-45 connector at one end and a DB-9 female connector
at the opposite end
at the opposite end
•
(1) 6 ft. shielded Category 5 straight through cable (STP) with RJ-45 connector
•
CD containing user documentation and a backup copy of the ETEP software
Rack Mount Installation: ET10000A
The ET10000A can be mounted in a standard 19-inch rack using the mounting kit, or simply placed on a
rack shelf or solid surface. Before installing the ET10000A in a 19-inch rack, review the rack-mounting
guidelines listed in
rack shelf or solid surface. Before installing the ET10000A in a 19-inch rack, review the rack-mounting
guidelines listed in
To mount the ET10000A in a standard 19-inch equipment rack, have the following tools and materials
available:
available:
•
Two mounting brackets, supplied in the Accessory Kit
•
16 small black screws, and 4 large silver screws (#10-32), supplied in the Accessory Kit
•
#1 Phillips and #2 Phillips screwdrivers (user-supplied)
CAUTION
In order to safely and securely and install the ET10000A in a rack, you must use the mounting rails
supplied in the Accessory Kit. Other rails may fail to properly support the weight of the ET10000A.
supplied in the Accessory Kit. Other rails may fail to properly support the weight of the ET10000A.
To install the ET10000A in a rack:
1 Place the unit on a solid surface, with the top facing up. Position the mounting brackets on each side
1 Place the unit on a solid surface, with the top facing up. Position the mounting brackets on each side
of the appliance, oriented as shown in
Figure 36
Mounting bracket orientation
2 Attach the mounting brackets to each side of the unit using the small black screws provided in the
accessory kit, and a #1 Phillips screwdriver, as shown in