Cisco Systems 566 Manual De Usuario
Chapter 4 Installing Hardware Options
Installing Adapters
4-10
Cisco Content Engine 511 and 566 Hardware Installation Guide
OL-5756-01
Installing the Fibre Channel Adapter
To install the Fibre Channel adapter, follow these steps:
Step 1
Check the system board and locate the correct PCI-X slot for the Fibre Channel
card.
card.
Step 2
Power down any connected peripheral devices and then power down the Content
Engine.
Engine.
Step 3
Disconnect the power cords.
Step 4
Remove the cover. (See the
Step 5
Remove the expansion slot cover. (See
.)
Step 6
Align the adapter with the slot 2 connector on the riser card. Carefully press the
adapter into the expansion slot until it is fully seated and secure. (See
adapter into the expansion slot until it is fully seated and secure. (See
Step 7
Reinstall the riser card. Make sure that the riser card is fully seated in the riser
card connector on the system board.
card connector on the system board.
Step 8
Connect one end of an LC-LC Fibre Channel cable to the optical interface
connector on the Fibre Channel adapter card. Connect the other end to a Fibre
Channel device.
connector on the Fibre Channel adapter card. Connect the other end to a Fibre
Channel device.
Step 9
Carefully install and secure the cover. (See the
Step 10
Connect the power cables.
Step 11
Power on all external Fibre Channel devices; then power on the Content Engine.
Step 12
Verify the installation by checking the LEDs. (See
.)
Troubleshooting the Fibre Channel Adapter Installation
Three types of adapter installation problems might cause your Fibre Channel
adapter to function incorrectly:
adapter to function incorrectly:
•
Hardware problems
•
System configuration problems
•
Fibre Channel problems