Cisco Systems 566 Manual De Usuario
4-11
Cisco Content Engine 511 and 566 Hardware Installation Guide
OL-5756-01
Chapter 4 Installing Hardware Options
Installing Adapters
Hardware Problems
Take the following actions to determine if your installation problem is caused by
the hardware:
the hardware:
1.
Verify that all adapters are installed securely.
2.
Verify that all cables are attached securely to the correct connectors. Be sure
that one end of the LC-LC Fibre Channel cable is attached to the optical
interface connector and that the other end is connected to the Fibre Channel
device.
that one end of the LC-LC Fibre Channel cable is attached to the optical
interface connector and that the other end is connected to the Fibre Channel
device.
3.
Verify that the Fibre Channel adapter is installed correctly and is fully seated
in the correct expansion slot.
in the correct expansion slot.
4.
Verify that all peripheral devices are turned on.
System Configuration Problems
Verify that the Fibre Channel adapter card is installed in the correct PCI-X slot. If
you still have a system configuration problem, contact Cisco technical support for
assistance. (See the
you still have a system configuration problem, contact Cisco technical support for
assistance. (See the
Fibre Channel Problems
To determine if your installation problem is caused by an attached Fibre Channel
device, perform the following tasks:
device, perform the following tasks:
1.
Verify that all of the Fibre Channel devices were turned on before you turned
on the Content Engine.
on the Content Engine.
2.
Ensure that all cables are connected properly.
3.
Verify that you configured your RAID storage subsystems using the utilities
provided by the manufacturer.
provided by the manufacturer.
4.
If your Fibre Channel switch supports zoning, make sure that your peripheral
device is configured to the same switch zone as the Fibre Channel adapter.
device is configured to the same switch zone as the Fibre Channel adapter.