Sanyo HF15000L Manual De Usuario
Remote Control Battery Installation
1
2
3
Open the battery
compartment lid.
Install new batteries into
the compartment.
Replace the
compartment lid.
Two AAA size batteries
For correct polarity (+ and –),
be sure battery terminals are
in contact with pins in the
compartment.
To ensure safe operation, please observe the following precautions :
l
Use two (2) AAA or LR03 type alkaline batteries.
l
Always replace batteries in sets.
l
Do not use a new battery with a used battery.
l
Avoid contact with water or liquid.
l
Do not expose the remote control to moisture or heat.
l
Do not drop the remote control.
l
If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.
l
Risk of an explosion if battery is replaced by an incorrect type.
l
Dispose of used batteries according to the instructions or your local disposal rule or guidelines.
Part Names and Functions
15
Pull up the lid
and remove it.
Point the remote control toward the projector (to Infrared
Remote Receivers). The operating distance and angle
between the receivers and the remote control must be
shorter than 16.4’ (5 m) and less than 60 degrees.
Infrared Remote Receivers are located on the front,
rear, and top panels. You can activate only necessary
receivers. (pp. 10, 63).
16.4’
(5 m)
(5 m)
Remote Control Receivers and Operating Range
The remote control can be used as a wired remote control. Wired remote control helps you use the remote control outside
of the operating range (16.4’/ 5 m). Connect the remote control and the projector with the remote control cable (sold
separately). Connected with the remote control cable, the remote control does not emit wireless signal.
Wired Remote Control
16.4’
(5 m)
(5 m)
✔
Note:
• When hanging the projector from the ceiling, select the
Infrared Remote Receiver which is located farther away
from the fluorescent light (p.63).
from the fluorescent light (p.63).
• When placing the projector in the horizontal position, as
fluorescent light may negatively affect the remote control
signals, it is recommended to select either “Back” or
“Front” to prevent the receiver on top of the projector from
picking up the signals from the remote control. (p.63)
signals, it is recommended to select either “Back” or
“Front” to prevent the receiver on top of the projector from
picking up the signals from the remote control. (p.63)