Sanyo HF15000L Manual De Usuario

•  

After cleaning or replacing the filter, 

i

nsert the AMC unit 

completely. If not, the projector cannot be turned on. 

•  

Do not put anything into the air vents. Doing so may 

result in malfunction of the projector.

•  

Do not wash the filters in water or any other liquid. 

Otherwise the filters may be damaged.

•  

When using a vacuum cleaner to remove the dust on 

the mesh filter, be careful as the filter tears easily.

•  When the mesh filter gets too dirty, contact your authorized 

dealer or service center.

Replacement filter can be ordered through your dealer. When ordering, give the following 

information to the dealer.

 

l

 

 

: 

      PLC-HF15000L

 

l

 

 

Replacement Filters (sold as a set): 610 354 6902 (service parts code)

      An Electrostatic Pleated Filter

     

An Electrostatic Honeycomb Filter

Holder A

Holder B

Holder B

Holder A

Electrostatic 
pleated filter

Electrostatic 
honeycomb filter

Slide forward a pair of the holders: A and B, loosen the 3 

screws that secure the holders, and remove the holders.

After inserting your fingers through the slits and lifting 

the filters on the mesh filter to remove them easily, 

remove the filters one by one, and if necessary, suck up 

the dust accumulated on the mesh filter and the frame 

with a vacuum cleaner.

Put the new electrostatic honeycomb filter on the 

mesh filter, the new electrostatic pleated filter on 

the honeycomb filter, the holders on the electrostatic 

pleated filter, respectively, and then fix with the screws. 

Slide backward the holders until the arrow marks on the 

holders are aligned with those on the AMC unit. 

Place the AMC unit back into the projector and fix it 

with the 2 screws. 

Plug the power cord, power on the projector and reset 

the filter counter. 

Screws

Slit

Slit

Loosen the 2 screws that secure the AMC unit and 

pull it out.

Remove the dust on the projector and air vents.

Press the ON/STAND-BY button on the side control 

or the STAND-BY button on the remote control, flip 

the Main On/Off Switch off, and then unplug the AC 

power cord from the AC outlet.

AMC unit

Screws