Viewsonic PJ1172 Manual De Usuario

This projector provides the NETWORK function. If you use this function, please consult 

your dealer for information.
To start, connect the NETWORK port to a gateway device via a RJ-45 (10BASE-1) cable, 

then set up the projector according to the Network environment in which you use it.
When you use a Network unsuitable to the DHCP function

Please set the IP Address, the Subnet Mask, the Gateway and the DHCP (on/off) using the 

NETWORK menu, referring to the section “NETWORK Menu”.
When you use a Network suitable to the DHCP function or has been set up

You can set the IP Address, the Subnet Mask, the Gateway and the DHCP (on/off) using a 

Web Browser of the computer connected to the Network. Although it needs a Web Browser 

of Internet Explorer 4.0 or higher.
Input the same IP address as set to the projector, to the Web Browser of the computer 

connected to LAN.
ex. Case of IP Address = 192.168.1.11
1) Input “http://192.168.1.11”.

2) Click “ENTER”.

3) Input the required data according to the screen.

4) Make sure of the input data, then click "Write".

These setting will be active after reboot. 

These setting will be stored, and used when 

DHCP is OFF.

5) Click “Return to top page”.

6) Click “REBOOT” to complete this operation.