Citizen iDP-3210 Manual De Usuario
iDP-3210 User’s Manual
62/67
CITIZEN
(38) Data Input Control (ESC = n)
Code : [1B]h + [3D]h + n
* {0 is less than or equal to n is less than or equal to FF} Data is described in Hex code.
Selecting equipment in which data input from the host is effective.
* {0 is less than or equal to n is less than or equal to FF} Data is described in Hex code.
Selecting equipment in which data input from the host is effective.
•
Each bit of n indicates as follows:
VALUE
BIT
EQUIPMENT
0
1
0
Printer
Invalid
Valid
1
Not defined
2
Not defined
3
Not defined
4
Not defined
5
Not defined
6
Not defined
7
Not defined
•
When the printer has not been selected, this printer abandons all received data until it
is selected by this command.
•
Even when the printer has not been selected, it can become BUSY state through printer
operation.
•
The initial value of n is "1".
(39) Aligning the characters (ESC a n)
Code : [1b]h + [61]h + n
* {0 is less than or equal to n is less than or equal to 2} Data is described in Hex code.
All the printed data within one line are aligned in the specified position.
* {0 is less than or equal to n is less than or equal to 2} Data is described in Hex code.
All the printed data within one line are aligned in the specified position.
•
Depending on n value, positional alignment is carried out as in the table below:
n (Hex)
POSITION
0
Left end alignment
1
Centering
2
Right end alignment
•
This is valid only when n is inputted at the beginning of line.
•
The initial value of n is "0".
(40) Full Cut (ESC i)
Code : [1B]h + [69]h
Full cutting of paper is performed.
Full cutting of paper is performed.
•
This is valid only when n is inputted at the beginning of line.
(41) Partial Cut (ESC m)
Code : [1B]h + [6D]h
Partial cutting of paper is carried out.
Partial cutting of paper is carried out.
•
This is valid only when n is inputted at the beginning of line.
idp-3210 User's Manual