Samsung ML-3560 Series Manual De Usuario

Installing Printer Options

9.3

Follow steps 1 and 3 on page 9.1 to access the control 
board.

Push the latches at both ends of the DIMM slot away from 
the DIMM. Pull out the DIMM.

Place the DIMM in its original package or wrap it with a 
sheet of thin metal, such as aluminium foil, and store it in 
a box.

Follow from step 8 on page 9.2.

Check to see if there are any missing parts in your optional 
network card package.

• The ML-3561N and ML-3561ND comes with a built-in 

network interface card.

• If you use a ML-3560 user, you need to install an optional 

network interface card.

• If you want to use the printer in both wired and wireless 

network environments, you need to install an optional 
wired/wireless network interface card in the ML-3560, 
ML-3561N and ML-3561ND.

Ethernet 10/100 Base TX (Internal)

Ethernet 10/100 Base TX + 802.11b 
Wireless LAN (Internal)

Network Interface Card, Network 
Utilities CD and Network Printer Quick 
Guide

Wireless Network Interface Card, 
Network Utilities CD and Network 
Printer Quick Guide

• When you purchase a wired/wireless network interface 

card, the antenna connected to the card may not be 
separated from the card, depending on your country.

Review the precaution on page 9.1 and then follow this 
procedure to install the network in your printer.

Turn the printer power off and unplug all cables from the 
printer.

Remove the duplex-slot cover from the back of the printer.

If you installed an optional duplex unit, remove it from the 
printer.

Hold the control board cover and remove it. 

If you are replacing an existing network interface card with 
a new one, remove the two screws and the old card.

Align the connector on the network card with the 
connector on the control board. Make sure that the jacks 
on the card go through the holes. Push the card firmly into 
the connector on the control board until it is completely 
and securely in place.