Samsung CLP775ND Manual De Usuario

Basic setup_ 40

4.

basic setup

After installation is complete, you may want to set the machine’s default settings. Refer to the next section if you would like 
to set or change values. This chapter gives you step-by-step instructions for setting up the machine.

•

•

•

•

•

•

•

•

  

The print quality is affected by atmospheric pressure, which is determined 

by the height of the machine above sea level. The following information will 

guide you on how to set your machine to the best print quality or best quality 

of print.

Before you set the altitude value, find the altitude where you are using the 

machine.

•

For Windows user, see "Device Settings" on page 62.

•

For Macintosh, Linux, or Unix OS user, see "Using Smart Panel 

(Macintosh and Linux only)" on page 62.

•

If your machine is connected to the network, you can set the 

altitude via SyncThru™ Web Service.

•

You can also set the altitude in System Setup option on the 

machine’s display.

When you set the time and date, they are used in delay print. They are 

printed on reports. If, however, they are not correct, you need to change it 

for the correct time being.

If the machine’s power is cut off, you need to reset the correct time 

and date once the power has been restored.

1. Press 

 on the control panel.

2. Press up/down arrow to highlight System Setup and press OK.
3. Press up/down arrow to highlight Date & Time and press OK.
4. Press up/down arrow to select the date and time you want.
5. press OK to save the selection.

6. Press 

 to return to ready mode.

This menu item is available when the optional hard disk is installed.

You can set your machine to display the current time using either a 12-hour 

or 24-hour format.

1. Press 

 on the control panel.

2. Press the up/down arrow to highlight System Setup and press OK.
3. Press the up/down arrow to highlight Clock Mode and press OK.
4. Press the up/down arrow to select the other mode and press OK.

5. Press 

 to return to ready mode.

This menu item is available when the optional hard disk is installed.

To change the language that appears on the display, follow the steps below:

1. Press 

 on the control panel.

2. Press up/down arrow to highlight System Setup and press OK.
3. Press up/down arrow to highlight Language and press OK.
4. Press up/down arrow to display the language you want.
5. press OK to save the selection.

6. Press 

 to return to ready mode.

When there is no input for a certain period of time, the machine exits the 

current menu and goes in to the default settings. You can set the amount of 

time the machine will wait.

1. Press 

 on the control panel.

2. Press up/down arrow to highlight System Setup and press OK.
3. Press up/down arrow to highlight Job Timeout and press OK.
4. Press up/down arrow to select the time you want.
5. press OK to save the selection.

6. Press 

 to return to ready mode.

0