Samsung CLP-610 Series Manual De Usuario

9.1   

<Installing accessories>

Your machine is a full-featured model that has been optimized to meet 
most of your printing needs. Recognizing that each user may have 
different requirements, however, Samsung makes several accessories 
available to enhance your machine’s capabilities.

This chapter includes:
•

• Disconnect the power cord

Never remove the control board cover while the power is turned on.

To avoid the possibility of an electrical shock, always disconnect the 
power cord when installing or removing ANY internal or external 
accessories.

• Discharge static electricity

The control board and internal accessories (network interface card or 
memory module) are sensitive to static electricity. Before installing or 
removing any internal accessories, discharge static electricity from your 
body by touching something metal, such as the metal back plate on any 
device plugged into a grounded power source. If you walk around before 
finishing the installation, repeat this procedure to discharge any static 
electricity again.

Your machine has a dual in-line memory module (DIMM). Use this 
memory module slot to install additional memory.

The machine has two memory slots with a factory pre-installed memory 
module in one slot. When you are expanding the memory capacity, you 
can add a memory module to the vacant memory slot. It is strongly 
recommended that you expand a memory module in vacant memory slot 
only without removing the pre-installed memory module. If your machine 
has 128 MB memory capacity and you want to add 512 MB, the memory 
capacity expands up to 640 MB.

Order information is provided for optional memory module. (See 
"Accessories" on page 8.1.)

Turn the machine off and unplug all cables from the machine.

Open the control board cover. Release the screw, then lift up the 
cover slightly and pull the cover to the right.

If you want to remove an existing memory module, push the 
two latches at the ends of the module outward.

Take out a new memory module from the plastic bag.

Holding the memory module by the edges, align the memory 
module on the slot at about a 30-degree tilt. Make sure that the 
notches of the module and the grooves on the slot fit each other.

The notches and grooves illustrated above may not match 
those on an actual memory module and its slot.

Press the memory module into the slot with care until you hear a 
'click'. 

Do not press the memory module strongly or the module 
may be damaged. If the module does not seem to fit into 
the slot properly, carefully try the previous procedure again.

control board cover