Samsung SRP-350PLUSA&C Manual De Usuario

The SRP-350plus is set up at the factory to be appropriate for almost all users. It does, 
however, offer some settings for users with special requirements. 

It has DIP switches that allow you to change communication settings, such as 
handshaking and parity check, as well as print density. 

The SRP-350plus also has a near-end sensor for the paper. This can give you a warning 
when the paper is almost out. If you find that there is not enough paper remaining on the 
roll when the near-end sensor is triggered, you can change the near-end sensor setting. 
Rotate the near end sensor tab at front or rear position. (See the below figure) 

Control Panel 

ഗ POWER 
The POWER light is on whenever the printer is on. 

ഗ ERROR 
This indicates an error.   

ഗ PAPER 
This light indicates the near end of the paper roll. Install a new paper roll 
and the printer Will continue printing. When the light blinks, it indicates 
the self-test printing standby state or macro execution Standby state 
when the macro execution command is used. 

ഗ FEED 
The button can be disabled by the ESC c 5 command. Press the FEED 
button once to advance paper one line. You can also hold down the 
FEED button to feed paper continuously.