Samsung CLP-325W Manual De Usuario

Getting started_ 28

2.

getting started

This chapter gives you step-by-step instructions for setting up the USB connected machine and software.

•

•

•

•

•

•

  

This section shows the steps to set up the hardware as is explained in the 

Quick Installation Guide. Make sure you read the Quick Installation Guide 

first and follow the steps below.

Select a stable location.
Select a level, stable place with adequate space for air circulation. Allow 

extra space to open cover(s) and tray(s). 
The area should be well ventilated and away from direct sunlight or 

sources of heat, cold and humidity. Do not set the machine close to the 

edge of your desk or table.

Printing is suitable for altitudes under 1,000 m (3,281 ft). Refer to the 

altitude setting to optimize your printing (See "Altitude adjustment" on 

page 50).
Place the machine on a flat, stable surface so that there is no incline 

greater than 2 mm (0.08 inch). Otherwise, printing quality may be 

affected.

Unpack the machine and check all the enclosed items.

Remove tape holding the machine securely.

Load paper (See "Loading paper in the tray" on page 54).

Make sure that all cables are connected to the machine. 

Turn the machine on (See "Turning on the machine" on page 27).

This machine will not operate when the power main fails.

Print a demo page to make sure that the machine is operating correctly. 
To print a demo page

In ready mode, press and hold the Cancel (

) button for 2 seconds, then 

release. (CLP-325W(K)/CLP-326W only)

Also, you can use the Demo page (

) button for printing a demo 

page. This button is supported on CLP-320N(K)/CLP-321N only.

Machine software is occasionally updated for reasons like the release 

of new operating system and etc. If needed, download the latest 

version from the Samsung website. (www.samsung.com/printer)