OKI 6200E Manual De Usuario

Static Route Entry
If the Network Print Server has printed a configuration 

page showing the default address, but it cannot be 

reached through telnet, check the following:

•

Display the host’s routing tables with the ‘netstat -r’ 

command. Verify that the route has been set cor-

rectly.

•

If the route is set correctly, try pinging the device.

•

Verify that the Network Print Server is on the same 

subnet as the host from which you are telneting. As 

a drastic measure, try creating an isolated subnet 

with your host and the Network Print Server. If you 

are using 10BASE2, run the cable directly from the 

host to the Network Print Server. If using 10/

100BASE-T cabling, connect the host to the Net-

work Print Server through a hub not connected to 

any other host.

•

If the static route has been set up and can telnet to 

the Network Print Server, but your changes do not 

seem to be saved, check the host’s routing tables. 

You might have telneted to a different Network 

Print Server than the one you intended. While in 

telnet, select the second menu option, Show Net-

work/Printer Information. The hardware address 

and serial number are displayed. Verify that they 

are the same as the unit you are configuring.

•

Turn off the Network Print Server you want to con-

figure. Run telnet again. If you reach a different 

device, there is an IP address conflict.