OKI 6200E Manual De Usuario

Gleaning
If you ping the device and are not getting a response, 

the glean is not working. Check the following possible 

problems:

•

Verify that the ARP table contains the correct hard-

ware and IP address by running the ‘arp -a’ com-

mand.

•

If you are getting a response, but the Network Print 

Server LED is still blinking green, power down the 

print server and try the ping again. There might be 

a different device answering to the ping.

•

Verify that the Network Print Server is on the same 

subnet as the computer running the ping.

•

The glean will not work if the Network Print Server 

has already defaulted to an IP address two minutes 

after power up. The LED will turn solid green and 

the device will print a configuration page. Power 

cycle the device and try the glean again.

RARP or BOOTP
If you are using a BOOTP or RARP server and the 

Network Print Server is not getting an IP address, 

check the following:

•

Verify that the BOOTP/RARP configuration files 

are correctly set up (“/etc/ethers” and “/etc/hosts” 

for RARP and “/etc/bootptab” for BOOTP). Verify 

that the files have the correct hardware address of 

the Network Print Server. If using RARP, check that 

the hostnames are the same between the “/etc/

ethers” and “/etc/hosts” files.