Zebra Technologies P1043301-005 Manual De Usuario

Installation
External ZebraNet 10/100 Print Server

P1043301-005  

11/21/13

Turn off (O) the printer. 

On the back of the printer, connect the external ZebraNet 10/100

 Print 

Server 

device 

to 

the 

parallel port.

 shows the location and provides an enlarged illustration of the parallel port.

Secure the wire locks.

On the back of the external ZebraNet 10/100

 

Print Server, connect an active Ethernet 

cable to the RJ-45 connector Ethernet connector.

Turn on (I) the printer.

The external ZebraNet 10/100

 

Print Server performs a Power On Self-Test (POST). This 

takes about 45 seconds. During the POST, the external ZebraNet 10/100

 Print 

Server 

Status LED (just below the TEST button) turns red and flashes on and off. Once the POST 
is successfully completed and the external ZebraNet 10/100

 

Print Server is fully 

initialized, the Status LED turns green. 

To check the status of the external ZebraNet 10/100

 

Print Server, press the Test button 

located on the back of the external ZebraNet 10/100

 Print 

Server. 

This prints out a configuration label of the external ZebraNet 10/100

 Print 

Server. 

To 

see 

a 

sample label, see 

.

Note • If there is not an active Ethernet cable attached to the external ZebraNet 
10/100

 

Print Server, the Status LED turns red and slowly flashes on and off.