Zebra Technologies P1043301-005 用户手册
Installation
External ZebraNet 10/100 Print Server
External ZebraNet 10/100 Print Server
36
P1043301-005
11/21/13
Installation Instructions
To install an external ZebraNet 10/100
Print Server, complete these steps:
1.
Turn off (O) the printer.
2.
On the back of the printer, connect the external ZebraNet 10/100
Print
Server
device
to
the
parallel port.
shows the location and provides an enlarged illustration of the parallel port.
Figure 2 • Rear of 105SL Printer
3.
Secure the wire locks.
4.
On the back of the external ZebraNet 10/100
Print Server, connect an active Ethernet
cable to the RJ-45 connector Ethernet connector.
5.
Turn on (I) the printer.
The external ZebraNet 10/100
Print Server performs a Power On Self-Test (POST). This
takes about 45 seconds. During the POST, the external ZebraNet 10/100
Print
Server
Status LED (just below the TEST button) turns red and flashes on and off. Once the POST
is successfully completed and the external ZebraNet 10/100
is successfully completed and the external ZebraNet 10/100
Print Server is fully
initialized, the Status LED turns green.
6.
To check the status of the external ZebraNet 10/100
Print Server, press the Test button
located on the back of the external ZebraNet 10/100
Print
Server.
This prints out a configuration label of the external ZebraNet 10/100
Print
Server.
To
see
a
sample label, see
.
Note • If there is not an active Ethernet cable attached to the external ZebraNet
10/100
10/100
Print Server, the Status LED turns red and slowly flashes on and off.
Parallel
Port
Connector
Printer Back