Polycom A Manual De Usuario

Polycom Immersive Telepresence (ITP) User’s Guide

3–10

 

Accessing the Content Monitors

This section describes how to access the tabletop content monitors in an ITP 

room.

Accessing the Content Monitors in RPX Suites

In RPX suites, there is one tabletop content monitor available for every two 

seats.

To access the content monitors in RPX suites:

Access the content monitors by removing the wooden covers located in 

the tabletop.

Press the power button at the bottom right corner of each screen to power 

on the content monitors.

Firmly pull up at the top of the content monitors to tilt the screen 

forward.

To make room on the table, you can place the wooden covers behind the 

content monitors.

When you are done using the content monitors, power them off, push 

them back down, and replace the wooden covers.

Accessing the Content Monitors in OTX Rooms

Accessing the Content Monitors in OTX 300 Rooms

In OTX 300 rooms, there are three content monitors located in the table.
Depending on how your system is configured, these three content monitors 

may automatically lift when content is shared; therefore, be sure to keep the 

area above the content monitors clear. Once the content monitors are raised, 

they will remain raised until the end of the call, even if no content is being 

shown. Also note that, if you are not in a call, content may also appear on the 

three main display screens as described on page 

If you want to manually override the automatic feature and freely move the 

content monitors up and down, you can do so by using the Content Monitor 

Lift button.

To access the content monitors in OTX 300 rooms:

Raise the content monitors by pressing the Content Monitor Lift button 

located on the tabletop in front of each content monitor.

When you are done using the content monitors, press the Content 

Monitor Lift button to lower each content monitor.