IBM 150 Manual De Usuario

Hints and Tips 

(0x000BEBC200 = 200000000 Hz = 200 MHz)

  • L2=04096 shows you the size of the Level 2 cache (= 4 MB).

You can determine the actual level of the service processor firmware if you 
search for the 

System Firmware

 entry in the 

lscfg -vp

 output.

System Firmware:

ROM Level.(alterable).......SPX98244

On CHRP/RPA systems (see 8.3.1, “The bootinfo Command” on page 216) 
there is a utility available that displays the status of the environmental 
sensors. The information displayed is the sensor name, physical location 
code, literal value of the sensor status, and the literal value of the sensor 
reading.

The sensor status can be any one of the following:

  • Normal: The sensor reading is within the normal operating range. 

  • Critical High: The sensor reading indicates a serious problem with the 

device. Run diagnostics on sysplanar0 to determine what repair action is 
needed. 

  • Critical Low: The sensor reading indicates a serious problem with the 

device. Run diagnostics on sysplanar0 to determine what repair action is 
needed.

  • Warning High: The sensor reading indicates a problem with the device. 

This could become a critical problem if action is not taken. Run 
diagnostics on sysplanar0 to determine what repair action is needed.

  • Warning Low: The sensor reading indicates a problem with the device. 

This could become a critical problem if action is not taken. Run 
diagnostics on sysplanar0 to determine what repair action is needed.

  • Hardware Error: The sensor could not be read because of a hardware 

error. Run diagnostics on sysplanar0 in problem determination mode to 
determine what repair action is needed.

  • Hardware Busy: The system has repeatedly returned a busy indication, 

and a reading is not available. Try the service aid again. If the problem 
continues, run diagnostics, on sysplanar0 in problem determination mode 
to determine what repair action is needed.