IBM 150 Manual De Usuario

RS/6000 43P 7043 Models 150 and 260 Handbook

To get the information, run the following command

/usr/lpp/diagnostics/bin/uesensor -l

and you will see a output similar to the this:

The status of the environmental sensors can also be shown by using the 
diagnostics service aid. To start diagnostics, enter: 

diag

If you are booting over the network, follow these steps:

1. Begin with your machine turned off or shut down your system properly if it 

is already running.

2. Power on the machine and enter the System Management Services (SMS) 

by pressing the F1 key.

3. The SMS menu displays on your screen. Select the Utilities option.

4. From the System Management Services Utilities menu, select the Remote 

Initial Program Load (RIPL) option.

5. From the screen, select the Set Address option.

6. Set or change the values displayed so they are correct for your client 

system.

Specify the IP address of:

  • The client machine you are booting in the 

client address

 field.

Sensor = Fan Speed 

Status = Normal 

Value = 2436 RPM 

Location Code = F1 

Sensor = Power Supply 

Status = Normal 

Value = Present and operational 

Location Code = V1 

Sensor = Power Supply 

*Status = Critical low 

Value = Present and not operational 

Location Code = V2