Acer Altos G900 Manual De Usuario

 3 Hardware configuration

76

To remove a PCI add-in board from a non-hot-plug slot

1

Disconnect the AC power cords from the power source or wall 
outlets.

2

Turn off all peripheral devices connected to the server system. 

3

Remove the rear access panel (refer to page 44) and the system 
board access panel (refer to page 51).

4

Release the latches on the front and rear retention mechanisms.

5

Grasp the board by the top edge or corners, carefully pull it out of 
the connector, and slide it free of the retention bracket.

6

If you are installing a new board, follow the instructions on 
page 75.  

If you are not installing another PCI add-in board, continue with 
the next step below.

7

Install a slot cover over the vacant slot in the back panel.

8

Install the system board access panel and the rear access panel.

For instructions, refer to page 52 and page 45 respectively.

9

Turn on any peripheral devices connected to the system.

10 Connect the power cord and turn on power to the server. 

AA G900 ug - EN.book Page 76 Wednesday, September 25, 2002 5:23 PM