Acer Altos G900 Manual De Usuario
3 Hardware configuration
78
The table below lists the LED states and the drive status indicated by
each state.
each state.
Installing and removing a hot-swap drive
in a carrier
in a carrier
To install a hot-swap drive in a carrier
Before you can install a drive in the hot-swap drive bay, you must
install the drive into a drive carrier. To install a hot-swap drive in a
carrier:
install the drive into a drive carrier. To install a hot-swap drive in a
carrier:
1
If the plastic air baffle is installed in the carrier, remove the four
screws that attach the air baffle to the carrier.
screws that attach the air baffle to the carrier.
Save the air baffle in case you later remove a drive.
LED state
Status
Solid green
The hard drive is present and powered on.
Flashing green
The hard drive is active.
Solid yellow
There is an asserted fault status on the hard drive.
Flashing yellow
A rebuild of the hard drive is in progress.
Off
The hard drive is not powered on.
Figure 40 - Removing a plastic air baffle from a carrier
AA G900 ug - EN.book Page 78 Wednesday, September 25, 2002 5:23 PM