Compaq S6035IL Manual De Usuario

    Upgrading and Servicing Guide 

3 Release the drive from the chassis by lifting the 

tab (1) on the latch drive bracket, and then sliding 
(2) the drive partway out of the bay. (The latch 
drive bracket secures the drives in their respective 
positions in the chassis.) 

4 Disconnect the power cable (1) and data cable (2) 

from the back of the drive you want to remove, as 
indicated in the following illustrations. Use a gentle 
rocking motion. Some units may have a sound 
cable. If so, disconnect the sound cable (3). 

 

 

 

 

 

 

 

 

5 Pull the drive out of the drive bay. 
6 If you are replacing the old drive with a new drive, 

remove the four guide screws (two on each side) 
from the old drive. You need these screws to install 
the new drive. 

 

1 If necessary, remove the existing drive. See 

“removing a drive“ on page 3. 

2 If you are adding a drive to an empty lower optical 

drive bay, you must remove the blank plate from 
the bay. To do so, insert a flat screwdriver into the 
blank plate slot (C) and rotate the screwdriver to 
break the blank plate out of the chassis. Discard the 
blank plate.