Graco 3A0415D Manual De Usuario

1. Clean the lubrication point to remove any 

potential contaminants.

2. Verify the thread of the lubricator corre-

sponds to the thread of the screw point.

3. Verify Dip Switches are correctly set. See 

Table 1, page 8.

4. Prime the grease line and all accessories 

with the same grease that is contained in 
the lubricator (See Parts, page 16 for a 
complete list of available grease car-
tridges).

5. Install reducers, extensions, grease line, 

etc. (if necessary).

6. Place drive unit on top of new lubrication 

canister until the teeth of both pieces are 
locked.

7. Screw the cover of the drive unit onto the 

lubrication canister - hand tighten only.

8. (If the plug is not 

already removed), 
remove the plug (A).

9. Install lubricator unit 

into adapter (B) (if it is 
not already installed).

10. Screw lubricator to 

lubrication point, 
hand tight only.

Before operation verify:

•

The lubricator does not have any visible 
damage.

•

The lubricator canister is filled with the 
requested grease or oil.

•

For oil filled lubrication canisters, an oil 
throttle must be attached.

•

New batteries have been installed.

•

The “VOL” switches 3 and 4 of the 4-way 
code switch match the correct size of the 
lubrication canister.

A

To ensure optimal lubrication:

•

Seal threads of all connecting parts with a 
suitable, standard sealant. 

•

Mount oil filled lubricators properly with the 
outlet pointing down.

•

Never screw in the lubricator a second time 
or the self-sealing threads will be dam-
aged.

•

For remote mounting installations, make 
sure bracket does not squeeze the lubrica-
tion canister as this could block the piston 
inside the canister.

B