Cisco Systems WSC4500X16SFP Manual De Usuario

You can set the number of times that the VMPS client attempts to contact the VMPS before querying the 
next server.

To configure the retry interval, perform this task:

This example shows how to change the retry count to 5 and to verify the change:

Switch# configure terminal

Enter configuration commands, one per line. End with CNTL/Z.

Switch(config)# vmps retry 5

Switch(config)# end

Switch# show vmps

VQP Client Status:

--------------------

VMPS VQP Version:   1

Reconfirm Interval: 60 min

Server Retry Count: 5

VMPS domain server: 172.20.130.50 (primary, current)

Reconfirmation status

---------------------

VMPS Action:         No Host 

You can display the following information about the VMPS with the show vmps command:

Switch# configure terminal

Enters global configuration mode.

Switch(config)# vmps retry 

count

Specifies the retry count for the VPQ queries. Default is 3. Range is 
from 1 to 10.

Switch(config)# end

Returns to privileged EXEC mode.

Switch# show vmps

Verifies the retry count.

VQP Version

The version of VQP used to communicate with the VMPS. The 
switch queries the VMPS using VQP Version 1.

Reconfirm Interval

The number of minutes the switch waits before reconfirming the 
VLAN-to-MAC-address assignments. 

Server Retry Count

The number of times VQP resends a query to the VMPS. If no 
response is received after this many tries, the switch starts to 
query the secondary VMPS.