Cisco Systems WSC4500X16SFP Manual De Usuario

The following example shows how to verify the configuration:

Switch# show policy-map flow-policy

 Policy Map flow-policy

   Class flow-class

     police 2000000 bps 10000 byte conform-action transmit exceed-action drop

Switch# show policy-map aggregate-policy

 Policy Map aggregate-policy

   Class aggregate-class

     police 50000000 bps 40000 byte conform-action transmit exceed-action drop

     service-policy flow-policy

Switch# show policy-map interface

FastEthernet6/1 

 Service-policy input: aggregate-policy

   Class-map: aggregate-class (match-all)

     132537 packets

     Match: access-group 10

     police: Per-interface

       Conform: 3627000 bytes Exceed: 0 bytes

     Service-policy : flow-policy

       Class-map: flow-class (match-all)

         8867 packets

         Match: access-group 20

         Match: flow  ip source-address

         police: Per-interface

       Conform: 1649262 bytes Exceed: 59601096 bytes

       Class-map: class-default (match-any)

         0 packets

         Match: any            0 packets

   Class-map: class-default (match-any)

     5 packets

     Match: any        5 packets

The per-port per-VLAN QoS feature enables you to specify different QoS configurations on different 
VLANs on a given interface. Typically, you will use this feature on trunk or voice VLANs (Cisco IP 
Phone) ports, as they belong to multiple VLANs.

To configure per-port per-VLAN QoS, perform this task:

Switch(config)# interface {fastethernet | gigabitethernet | 

} 

slot/interface

 | 

number 

Selects the interface to configure.

Switch(config-if)# vlan-range 

vlan_range

Specifies the VLANs involved.

Switch(config-if-vlan-range)# service-policy 

{input | output} 

policy-map

Specifies the policy-map and direction.

Switch(config-if-vlan-range)# exit

Exits class-map configuration mode.