Cisco Systems WSC4500X16SFP Manual De Usuario
27-43
Software Configuration Guide—Release 12.2(25)SG
OL-7659-03
Chapter 27 Configuring Quality of Service
Configuring QoS
Police 100m 16k conform transmit exceed drop
Interface Gigabit 3/1
Switchport
Switchport trunk encapsulation dot1q
Switchport trunk allowed vlan 101-102
Vlan range 101
Service-policy input P31_QoS
Service-policy output P31_QoS
Vlan range 102
Service-policy input P32_QoS
Service-policy output P32_QoS
Example 2
Let us assume that interface Gigabit Ethernet 6/1 is a trunk port and belongs to VLANs 20, 300-301, and
400. The following example shows how to apply policy-map p1 for traffic in VLANs 20 and 400 and
policy map p2 to traffic in VLANs 300 through 301:
400. The following example shows how to apply policy-map p1 for traffic in VLANs 20 and 400 and
policy map p2 to traffic in VLANs 300 through 301:
Switch# configure terminal
Switch(config)# interface gigabitethernet 6/1
Switch(config-if)# vlan-range 20,400
Switch(config-if-vlan-range)# service-policy input p1
Switch(config-if-vlan-range)# exit
Switch(config-if)# vlan-range 300-301
Switch(config-if-vlan-range)# service-policy output p2
Switch(config-if-vlan-range)# end
Switch#
Example 3
The following command shows how to display policy-map statistics on VLAN 20 configured on Gigabit
Ethernet interface 6/1:
Ethernet interface 6/1:
Switch# show policy-map interface gigabitethernet 6/1 vlan 20
GigabitEthernet6/1 vlan 20
Service-policy input: p1
Class-map: class-default (match-any)
0 packets
Match: any
0 packets
police: Per-interface
Conform: 0 bytes Exceed: 0 bytes
Example 4
The following command shows how to display policy-map statistics on all VLANs configured on Gigabit
Ethernet interface 6/1:
Ethernet interface 6/1:
Switch# show policy-map interface gigabitethernet 6/1
GigabitEthernet6/1 vlan 20
Service-policy input: p1