Cisco Systems EA6500 Manual De Usuario

This example shows how to verify the configuration:

Router# show policy-map max-pol-ipp5 

 Policy Map max-pol-ipp5

  class  ipp5

  class ipp5

    police flow 10000000 10000 conform-action set-prec-transmit 6 exceed-action  

policed-dscp-transmit

    trust precedence

    police 2000000000 2000000 2000000 conform-action set-prec-transmit 6 exceed-action 

policed-dscp-transmit

Router#

PFC QoS does not support the output service-policy keyword.

To attach a policy map to an interface, perform this task: 

Aggregate policing works independently on each DFC-equipped switching module and independently 
on the PFC2, which supports any non-DFC-equipped switching modules. Aggregate policing does not 
combine flow statistics from different DFC-equipped switching modules. You can display aggregate 
policing statistics for each DFC-equipped switching module and for the PFC2 and any 
non-DFC-equipped switching modules supported by the PFC2.

This example shows how to attach the policy map named pmap1 to Fast Ethernet port 5/36:

Router# configure terminal 

Enter configuration commands, one per line.  End with CNTL/Z.

Router(config)# interface fastethernet 5/36 

Router(config-if)# service-policy input pmap1

Router(config-if)# end

Router(config)# interface {{vlan vlan_ID} | 

{type

1

 slot/port} | {port-channel number}}

1.

type = ethernet, fastethernet, gigabitethernet, tengigabitethernet, ge-wan, pos, or atm 

Selects the interface to configure.

Router(config-if)# service-policy input 

policy_map_name 

Attaches a policy map to the input direction of the 
interface. 

Router(config-if)# no service-policy input 

policy_map_name 

Removes the policy map from the interface. 

Router(config-if)# end 

Exits configuration mode.

Router# show policy-map interface {{vlan vlan_ID} 

| {type

 slot/port} | {port-channel number}} 

Verifies the configuration.