Cisco Systems EA6500 Manual De Usuario

This example shows how to verify the configuration:

Router# show policy-map interface fastethernet 5/36 

 FastEthernet5/36 

  service-policy input: pmap1

    class-map: cmap1 (match-all)

      0 packets, 0 bytes

      5 minute rate 0 bps

      match: ip precedence 5

  class cmap1

    police 8000 8000 conform-action transmit exceed-action drop

    class-map: cmap2 (match-any)

      0 packets, 0 bytes

      5 minute rate 0 bps

      match: ip precedence 2

        0 packets, 0 bytes

        5 minute rate 0 bps

  class cmap2

    police 8000 10000 conform-action transmit exceed-action drop

Router#

To enable or disable microflow policing (see the 

), perform this task: 

This example shows how to disable microflow policing:

Router# configure terminal 

Enter configuration commands, one per line.  End with CNTL/Z.

Router(config)# no mls qos flow-policing 

Router(config)# end 

Router# 

This example shows how to verify the configuration:

Router# show mls qos | include Microflow 

  Microflow QoS is disabled globally

Router#

To apply microflow policing to multicast traffic, you must enter the mls qos bridged command on the 
Layer 3 multicast ingress interfaces.

Router(config)# mls qos flow-policing 

Enables microflow policing. 

Router(config)# no mls qos flow-policing 

Disables microflow policing. 

Router(config)# end 

Exits configuration mode.

Router# show mls qos 

Verifies the configuration.