Cisco Systems EA6500 Manual De Usuario

The following configuration restrictions apply during the startup synchronization process:

You cannot perform configuration changes during the startup (bulk) synchronization. If you attempt 
to make configuration changes during this process, the following message is generated:

Config mode locked out till standby initializes

If configuration changes occur at the same time as a supervisor engine switchover, these 
configuration changes are lost.

These sections describe how to configure supervisor engine redundancy:

To configure RPR or RPR+, perform this task:

This example shows how to configure the system for RPR+ and display the redundancy state:

Router> enable

Router# configure terminal

Enter configuration commands, one per line.  End with CNTL/Z.

Router(config)# redundancy

Router(config-red)# mode rpr-plus

Router(config-red)# ^Z

Router# show redundancy states 

       my state = 13 -ACTIVE

     peer state = 1  -DISABLED

           Mode = Simplex

           Unit = Primary

        Unit ID = 1

Redundancy Mode (Operational) = Route Processor Redundancy Plus

Redundancy Mode (Configured)  = Route Processor Redundancy Plus

     Split Mode = Disabled

   Manual Swact = Disabled  Reason: Simplex mode

 Communications = Down      Reason: Simplex mode

Router(config)# redundancy 

Enters redundancy configuration mode.

Router(config-red)# mode {rpr | rpr-plus} 

Configures RPR or RPR+. When this command is 
entered, the redundant supervisor engine is reloaded and 
begins to work in RPR or RPR+ mode.

Router# show running-config 

Verifies that RPR or RPR+ is enabled.

Router# show redundancy states 

Displays the operating redundancy mode.