Cisco Systems SPS224G4 Manual De Usuario
QoS Commands
show class-map
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
271
23
The Class-Map Configuration mode enables entering up to two match Class-map
Configuration mode commands to configure the classification criteria for the
specified class. If two match Class-map Configuration mode commands are
entered, each should point to a different type of ACL (e.g., one to an IP ACL and
one to a MAC ACL). Since packet classification is based on the order of the
classification criteria, the order in which the match Class-Map Configuration mode
commands are entered is important.
Configuration mode commands to configure the classification criteria for the
specified class. If two match Class-map Configuration mode commands are
entered, each should point to a different type of ACL (e.g., one to an IP ACL and
one to a MAC ACL). Since packet classification is based on the order of the
classification criteria, the order in which the match Class-Map Configuration mode
commands are entered is important.
If there is more than one match statement in a match-all class map and the same
classification field appears in the participating ACLs, an error message is
generated.
classification field appears in the participating ACLs, an error message is
generated.
NOTE
A class map in match-all mode cannot be configured if it contains both an IP ACL
and a MAC ACL with an ether type that is not 0x0800.
and a MAC ACL with an ether type that is not 0x0800.
Example
The following example creates a class map called class1 and configures it to
check that packets match all classification criteria in the class map match
statement.
check that packets match all classification criteria in the class map match
statement.
Console(config)# class-map class1 match-all
Console(config-cmap)#
show class-map
The show class-map Privileged EXEC mode command displays all class maps.
Syntax
show class-map [
class-map-name
]
Parameters
•
class-map-name
— Specifies the name of the class map to be displayed.