Cisco Systems SFS 3012 Manual De Usuario
15
NOTE: The power socket on the back (service end) of the Topspin 360 corresponds to the power
supply module on the same side of the Server Switch.
supply module on the same side of the Server Switch.
Removing a Power Supply
To remove the power supply, perform the following steps:
1. Remove the power cord from the power supply.
2. Disengage the power supply by pulling it toward you.
3. Slide the power supply out of the chassis.
4. Fasten a blanking panel to the empty chassis bay to ensure appropriate cooling.
1. Remove the power cord from the power supply.
2. Disengage the power supply by pulling it toward you.
3. Slide the power supply out of the chassis.
4. Fasten a blanking panel to the empty chassis bay to ensure appropriate cooling.
NOTE: The blanking panel is a flat sheet of metal with the same dimensions as the power module
faceplate.
faceplate.
Blower Trays
The hot-swappable blower trays (fans) of your Topspin 360 maintain the internal temperature of your
Server Switch. You do not need to turn off power to the chassis to replace a blower tray. Access the
blower tray from the front (bezel end) of the Topspin 360 chassis.
Server Switch. You do not need to turn off power to the chassis to replace a blower tray. Access the
blower tray from the front (bezel end) of the Topspin 360 chassis.
displays the blower trays
in the chassis.
Figure 2-11: Blower Trays
NOTE: Your chassis requires two fully-functioning blower modules at all times.
Install Blower Trays
To insert a blower tray, perform the following steps:
1. Ground yourself appropriately.
2. Remove the blower tray from any packaging.
1. Ground yourself appropriately.
2. Remove the blower tray from any packaging.
Blower Tray
Blower Tray