Nortel Networks 2000 Manual De Usuario
134 Chapter 2 Network configuration
208700-B
•
When you set any trunk member to Disabled (not active) through the Port
Configuration screen or through network management, the trunk member is
removed from the trunk. The trunk member has to be reconfigured to rejoin
the trunk through the Trunk Configuration screen on the CI menus, or another
management system. A screen prompt precedes this action when you are
using CI menus. A trunk member cannot be disabled if there are only two
trunk members on the trunk.
Configuration screen or through network management, the trunk member is
removed from the trunk. The trunk member has to be reconfigured to rejoin
the trunk through the Trunk Configuration screen on the CI menus, or another
management system. A screen prompt precedes this action when you are
using CI menus. A trunk member cannot be disabled if there are only two
trunk members on the trunk.
•
You cannot configure a trunk member as a monitor port (see Chapter 3).
•
Trunks cannot be monitored by a monitor port; however, trunk members can
be monitored (see
be monitored (see
”).
•
All trunk members must have identical IGMP configurations.
•
If you change the IGMP snooping configuration for any trunk member, the
IGMP snooping settings for all trunk members change.
IGMP snooping settings for all trunk members change.
How the MultiLink Trunk reacts to losing distributed trunk
members
members
If your MultiLink Trunk (
) spans separate units in a stack configuration
and any of those units (or trunked MDAs) becomes inactive from a loss of power
or unit failure, the unaffected trunk members remain operational.
or unit failure, the unaffected trunk members remain operational.