3com 5500-SI Manual De Usuario

C

HAPTER

 7: GVRP C

ONFIGURATION

The GVRP configuration tasks include configuring the timers, enabling GVRP, and 
configuring the GVRP port registration mode.

The port on which GVRP will be enabled must be configured to the Trunk port.

Refer to Table 103 for configuration procedures

You can use the reset garp statistics [ interface interface-list ] command to clear the 
GARP statistics.

The ranges of the timers vary depending on the values of other timers. You can set a 
timer to a value out of the current range by set the associated timer to another value.

Enter system view

system-view

-

Enable GVRP globally.

gvrp

Required
By default, GVRP is disabled globally.

Configure the LeaveAll 
timer

garp timer leaveall 
timer-value

Optional
By default, the LeaveAll timer is set to 1,000 
centiseconds.

Enter Ethernet port 
view

interface 
interface-type 
interface-number

This port must be a Trunk port.

Enable GVRP on the 
port

gvrp

Required
By default, GVRP is disabled on port.After enabling 
GVRP on the Trunk port, you are not allowed to 
change the port type from Trunk to another.

Configure the Hold, 
Join, and Leave timers

garp timer { hold | 
join | leave } 
timer-value

Optional
By default, the Hold, Join, and Leave timers are set 
to 10, 20, and 60 centiseconds respectively.

Configure GVRP port 
registration mode

gvrp registration { 
normal | fixed | 
forbidden }

Optional
You can choose one of the three modes.By 
default, GVRP port registration mode is normal.

Display the GARP 
statistics

display garp 
statistics [ interface 
interface-list ]

You can execute the display commands in any 
view.

Display the values of 
the GARP timers

display garp timer [ 
interface 
interface-list ]

Display the GVRP 
statistics

display gvrp statistics 
[ interface 
interface-list ]

Display global GVRP 
status

display gvrp status