3com 5500-SI Manual De Usuario

GVRP Configuration 115

Table 104 describes the relations between the timers:

You should enable GVRP on the switches to implement the dynamic registration and 
update of VLAN information between the switches.

Figure 27   Network diagram for GVRP configuration

1 Configure switch A:

a Enable GVRP globally.

<S5500> system-view

[S5500] gvrp

b Configure the port Ethernet1/0/1 to the Trunk port, and allow all VLAN packets to 

pass through the port.

[S5500] interface Ethernet1/0/1

[S5500-Ethernet1/0/1] port link-type trunk

[S5500-Ethernet1/0/1] port trunk permit vlan all

c Enable GVRP on the Trunk port.

[S5500-Ethernet1/0/1] gvrp

2 Configure switch B:

a Enable GVRP globally.

<S5500> system-view

[S5500] gvrp

Hold

10 centiseconds

This upper threshold is less than or equal to 
one-half of the value of the Join timer. You can 
change the threshold by changing the value of 
the Join timer.

Join

This lower threshold is greater 
than or equal to twice the value of 
the Hold timer. You can change 
the threshold by changing the 
value of the Hold timer.

This upper threshold is less than one-half of the 
value of the Leave timer. You can change the 
threshold by changing the value of the Leave 
timer.

Leave

This lower threshold is greater 
than twice the value of the Join 
timer. You can change the 
threshold by changing the value of 
the Join timer.

This upper threshold is less than the value of the 
LeaveAll timer. You can change the threshold by 
changing the value of the LeaveAll timer.

LeaveAll

This lower threshold is greater 
than the value of the Leave timer. 
You can change threshold by 
changing the value of the Leave 
timer.

32,765 centiseconds