3com CM 4000 Manual De Usuario

Note 2: If the cursor mode in the switcher status display will not work, it may be that no CP 3000 was defined
for the VGA on the MPK Devices table (page 5−114).

As a supervisory system, the VGA / CP 3000 can be configured such that it can unprotect or unlock any output
shown on the display.

— If the panel has been so configured on a permanent basis (as described on page 5−114), place the cursor on the

output and press PROTECT (or LOCK) and TAKE.

— If the panel has not been configured permanently, login to the panel using a 90 level or above  password. This

will allow use of the force unprotect/unlock command until logout.

For additional protect/lock information − See page 6−12.

Thomson             WXYZ TELEVISION FACILITY CONTROL SYSTEM            PAGE: 01
May 10, 1999              MACHINE & DELEGATION STATUS                  12:34:56
−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−
MACHINE    STATUS   LINKAGE    MCS     STU     ENG     TAPE
−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−
VT01       STOP     StuMC      StuMC
VT02
VT03
VT04
VT05
VT06
VT07
VT08
VT09
VC01       STOP     StuMC     ASSIGNED     
VC02       STOP               ASSIGNED
VC03
VC04
VC05

Figure 6−172. Machine  & delegation
status page (example).

Up to 32 

Delegation

groups

A machine and delegation status page (Figure 6−172) can provide a list of all VTRs and other machines listed on the Machine
Control Devices table (page 5−135). The UP and DOWN buttons (or arrow buttons on the CP 3020) will step through addi-
tional pages of machines. Hold the key down to auto−repeat.

Depending on the machine, TMC (Transport Motion Control) status is shown as follows:

     OFF     NOT REM     EJECT     STOP     STOP−RDY     PLAY     VAR PLAY     FAST F     REWIND     SHUTTLE +     SHUTTLE −

Note: Delegation Groups are not supported by Jupiter XPress.

To enter cursor mode, press SELECT on the CM 4000 (or CURSOR MODE on the CP 3020). This will cause
the name of the first machine to appear in reverse video. When in cursor mode, the UP and DOWN buttons (or
arrow buttons) will move the cursor from one machine to another. A machine pointed to by the cursor is automati-
cally selected as the machine to be controlled by the adjacent MC 3000 Machine Control Panel (i.e., the MC 3000
connected to the CM 4000 providing the VGA display).