SMC Networks 10/100/1000 SMCGS8P-Smart Manual De Usuario
IP C
OMMANDS
3-73
IP Commands
An IP address may be used for management access to the switch
over your network. By default, the switch uses DHCP to assign IP
settings to VLAN 1 on the switch. If you wish to manually
configure IP settings, you need to change the switch’s
user-specified defaults (IP address 0.0.0.0 and netmask 255.0.0.0)
to values that are compatible with your network. You may also
need to a establish a default gateway between the switch and
management stations that exist on another network segment.
over your network. By default, the switch uses DHCP to assign IP
settings to VLAN 1 on the switch. If you wish to manually
configure IP settings, you need to change the switch’s
user-specified defaults (IP address 0.0.0.0 and netmask 255.0.0.0)
to values that are compatible with your network. You may also
need to a establish a default gateway between the switch and
management stations that exist on another network segment.
Command
Function
Mode Page
ip address
Sets the IP address for this device
IC
ip dhcp restart
Submits a BOOTP or DCHP client
request
request
PE
ip
default-gateway
default-gateway
Defines the default gateway through
which an in-band management station
can reach this device
which an in-band management station
can reach this device
GC
show ip interface Displays the IP settings for this device
PE
show ip redirects Displays the default gateway configured
for this device
PE
ping
Sends ICMP echo request packets to
another node on the network
another node on the network
NE,
PE
PE
b_mgmt.book Page 73 Tuesday, July 8, 2003 5:24 PM