SMC Networks 10/100/1000 SMCGS8P-Smart Manual De Usuario
C
OMMAND
L
INE
I
NTERFACE
3-126
cause the Spanning Tree to initiate reconfiguration when the
interface changes state, and also overcomes other STP-related
timeout problems. However, remember that Edge Port should
only be enabled for ports connected to an end-node device.
interface changes state, and also overcomes other STP-related
timeout problems. However, remember that Edge Port should
only be enabled for ports connected to an end-node device.
• This command has the same effect as the spanning-tree
portfast command.
Example
Related Commands
spanning-tree protocol-migration
Use this command to re-check the appropriate BPDU format to
send on the selected interface.
send on the selected interface.
Syntax
spanning-tree protocol-migration interface
interface
• ethernet unit/port-number
- unit - This is device 1.
- port-number
• port-channel channel-id (Range: 1-6)
Command Mode
Privileged Exec
Command Usage
If at any time the switch detects STP BPDUs, including
Configuration or Topology Change Notification BPDUs, it will
automatically set the selected interface to forced
Configuration or Topology Change Notification BPDUs, it will
automatically set the selected interface to forced
Console(config)#interface ethernet 1/5
Console(config-if)#spanning-tree edge-port
Console(config-if)#
Console(config-if)#spanning-tree edge-port
Console(config-if)#
b_mgmt.book Page 126 Tuesday, July 8, 2003 5:24 PM