SMC Networks 10/100/1000 SMCGS8P-Smart Manual De Usuario
S
PANNING
T
REE
C
OMMANDS
3-127
STP-compatible mode. However, you can also use the
spanning-tree protocol-migration command at any time to
manually re-check the appropriate BPDU format to send on the
selected interfaces (i.e., RSTP or STP-compatible).
spanning-tree protocol-migration command at any time to
manually re-check the appropriate BPDU format to send on the
selected interfaces (i.e., RSTP or STP-compatible).
Example
spanning-tree link-type
Use this command to configure the link type for the Rapid
Spanning Tree. Use the no form to restore the default.
Spanning Tree. Use the no form to restore the default.
Syntax
spanning-tree link-type {auto | point-to-point | shared}
no spanning-tree link-type
no spanning-tree link-type
• auto - Automatically derived from the duplex mode setting.
• point-to-point - Point-to-point link.
• point-to-point - Point-to-point link.
• shared - Shared medium.
Default Setting
auto
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• Specify a point-to-point link if the interface can only be
connected to exactly one other bridge, or a shared link if it can
be connected to two or more bridges.
be connected to two or more bridges.
• When automatic detection is selected, the switch derives the
link type from the duplex mode. A full-duplex interface is
considered a point-to-point link, while a half-duplex interface
is assumed to be on a shared link.
considered a point-to-point link, while a half-duplex interface
is assumed to be on a shared link.
Console(config)#interface ethernet 1/5
Console(config-if)#spanning-tree protocol-migration
Console(config-if)#
Console(config-if)#spanning-tree protocol-migration
Console(config-if)#
b_mgmt.book Page 127 Tuesday, July 8, 2003 5:24 PM