Schneider Electric KVM0108A Manual De Usuario

Examine the components at the time of delivery to be sure all parts are present and in good working 
order. Anything missing or damaged must be reported immediately to the shipping firm and to APC.

•  1 KVM0108A or KVM0116A KVM switch
•  1 firmware upgrade cable
•  1 NEMA 5-15 power cord

1 C13 - C14 power cord

•  1 rack mount bracket 
•  Literature Kit: Quick Start Guide, Safety Sheet, and China ROHS.

•  Do not connect the RJ-11 connector marked “UPGRADE” to a public 

telecommunication network.

•  Before working on the rack, make sure that the stabilizers are secured to the rack, 

extended to the floor, and that the full weight of the rack rests on the floor. Install 
front and side stabilizers on a single rack or front stabilizers for joined multiple 
racks before working on the rack.

•  Always load the rack from the bottom up, and load the heaviest item in the rack 

first.

•  Make sure that the rack is level and stable before extending a device from the rack.
•  Use caution when pressing the device rail release latches and sliding a device into 

or out of a rack; the slide rails can pinch your fingers.

•  After a device is inserted into the rack, carefully extend the rail into a locking 

position, and then slide the device into the rack.

•  Do not overload the AC supply branch circuit that provides power to the rack. The 

total rack load should not exceed 80 percent of the branch circuit rating.

•  Make sure that all equipment used on the rack, including power strips and other 

electrical connectors, is properly grounded.

•  Ensure that proper airflow is provided to devices in the rack.
•  Ensure that the operating ambient temperature of the rack environment does not 

exceed the maximum ambient temperature specified for the equipment by the 
manufacturer

•  Do not step on or stand on any device when servicing other devices in a rack.
•  Do not place the device on an unstable surface. If the device falls, serious damage 

will result.

•  Do not block ventilation openings. Overheating of internal components may occur.
•  Route the power cord and cables so that they cannot be stepped on or tripped 

over.