Schneider Electric KVM0108A Manual De Usuario

1

Power LED

Lights to indicate that the KVM switch is powered and ready to operate.

2

Port LEDs

The Port LEDs provide status information about their corresponding KVM Ports
• GREEN: The server attached to the port is On Line.
• RED: The server attached to the port is Selected (has KVM focus).
• GREEN + RED (ORANGE): The server attached to the port is On Line and Selected.
The LEDs are continuously ON under normal conditions. An LED will flash at half second 
intervals when its corresponding port is accessed under Auto Scan Mode or Skip Mode

3

Firmware Upgrade 
Recovery Switch

During normal operation and while performing a firmware upgrade, this switch should be in 
the “normal” position. If a firmware upgrade operation does not complete successfully, this 
switch is used to perform a firmware upgrade recovery (see “Firmware Upgrade Utility” on 
page 29).

4

Reset Switch

The switch is recessed and must be pushed with a small object, such as the end of a paper clip 
or a ballpoint pen. To perform a system reset, press and release when the unit is running.
Note: This does not clear User Account information. 

5

Station ID LED

The KVM switch's Station ID is displayed here. If this is a single station installation or the 
first station on the installation, the KVM switch ID is “01.” 
On a tiered installation, the KVM switch auto-senses its position and displays the station ID 
that corresponds to its place in the installation (see “Port ID Numbering” on page 12). 

6

Firmware Upgrade 
Port

The Firmware Upgrade Cable that transfers the firmware upgrade data from the 
administrator's computer to the KVM switch, plugs into this RJ-11 connector.

7

Console Port

The port is for installation with Rack LCD Console AP5717 or AP5719.

aem0465a

KVM0108A

KVM0116A