GarrettCom Quad Manual De Usuario

Magnum Quad-Series Fiber Switches 

Installation and User Guide (06/03) 

On the bottom-front of the unit, there are two retaining screws for each QPM card slot as 

well as two other retaining screws on the rear top of the module. These four screws are 

used to secure a QPM face plate in position. These screws are also used to secure the 

individual QPM cards, which can be subjected to significant forces from the attached 

cables.  (See Figure 3.9.1c)  

 

 

ocedure in Section 3.9.1 above.  

Step 2.  Screw down tightly the two 7/16 stand-off on the top of pre installed stand-off 

from the factory. 

p 3.  Align the two headers pin on the top of the two sets of socket fixed at the 

bottom side of the QPM module. (Note: After firmly attached the sockets and 

the header pin, move the mounted pins slightly tilted towards the front of the 

 connector socket slot. Align the connector pins on the bottom of 

the QPM card with the connector socket inside the unit.  

Up to four front-mounted QPM cards may be installed in one Magnum 5116

Fiber switch unit. Follow these steps to install a QPM. 

Step 1.  Remove top chassis cover. See pr

chassis.  

Step 4.    The figure here 

illustrates the basic 

layout of an 

individual QPM 

card. Each QPM 

card fits into the 

selected QPM

  1

QPM CARDS

J1      J2       J3
J4

Two retaining screws on the rear top  of
module

 

J1      J2       J3        J4

LED

Uplink
Switch

 

 

27 

.

.