GarrettCom 6K32 Manual De Usuario

Magnum 6K32 Managed Switch            Installation and User Guide (02/05) 

 

10 

.

.

 

Module, 6K8-RJ45      

The 6K32’s 8-port 

Copper port module, model 6K8-

RJ45, provides eight 10/100Mb 

switched RJ-45 ports. The 

10/100Mb switched ports 

normally (as a default setting) are independently N-way auto-negotiating for operation at 

10 or 100Mb speed in full- or half-duplex mode, i.e., each independently selects a mode 

and speed to match the device at the other end of the twisted pair cable.  (See Section 4.3 

for auto-negotiation details) 

On the model 6K8-RJ45 module, there are four LEDs for each port, two in the 

connector and two separate.  The LK (Link) LED indicates “ready for operation” on that 

port when lit. The blinking ACT (Activity) LED indicates receiving Activity on that port 

when lit. The 10/100 LED indicates operation at 100Mb speed when ON and at 10 Mb 

speed when OFF (when auto-negotiation is not disabled). The FDX/HDX LED is ON to 

indicate full-duplex operation and OFF to indicate half-duplex mode. A twisted pair 

cable must be connected into an RJ-45 port and the Link (LK) indicator for that port must 

be ON (indicating there is a powered-up device at the other end of the cable) in order for 

a LK LED to provide valid indications of operating conditions on that port.  

Using the MNS-6K software, the user may disable auto-negotiation and fix the 

desired operation of each RJ-45 port. MNS-6K Software allow to  select 10Mb or 100Mb 

speed and full- or half-duplex mode per-port as per user requirement. (See Magnum   

MNS-6K Software Manual for details info). See Section 4.3 for Up-Link switch. 

The combo six-port modules are combinations of copper and fiber media, 

available as four 10/100 switched RJ-45 copper ports and two 100Mb switched multi- 

        2                   4                      6                  8

F/ H

ACT

 

TX       LK     RX

 

TX       LK     RX