GarrettCom 6K32 Manual De Usuario

Magnum 6K32 Managed Switch            Installation and User Guide (02/05) 

 

29 

.

.

 

(#256 flat head ) which hold the PM Face plate card slot securely. These six screws 

shown in the picture below are used to secure a PM face plate in position, but unscrew 

only four of the screws as shown in Fig. below. These screws are also used to secure the 

individual 6KPM cards screen plate which can be subjected to significant forces from the 

attached cables.  (See Figure 3.5.1d) 

 

Up to four front-mounted 6KPM cards may be installed in one Magnum 6K32 

Managed Switch unit. Follow these steps to install a 6KPM. 

Step 1.  Remove top chassis cover. See procedure in Section 3.5.1 above.  

Step 2.  Placed Granddaughter board (as shown in fig. 3.5.2a and 3.5.2b) on the chassis 

built in stand off (female) provided at the front of the 6K32 Main Board and 

screw down tightly with the three 5/16 stand-off (male) on the top of the 

Granddaughter board The 5/16 stand off has been used to place the daughter 

board on the top of the granddaughter board and latch it securely.