GarrettCom 6K32 Manual De Usuario

Magnum 6K32 Managed Switch            Installation and User Guide (02/05) 

 

31 

.

.

 

Step 6.   Now screw down the daughter board with 7 #440 screws except the last two at 

the end, so that it holds the daughter board securely. The figure below shows the 

top view of 6KPM card after successfully installing the 6KPM cards inside the 

Magnum 6K32.  

Fig. 3.5.2g   Top View : 

Step 7.    Once the installation of granddaughter and daughter modules is done properly, 

the front panel screen plates(come along with the 6K-module) need to be properly placed 

on the front of the chassis cover to complete the installation process. 

Step 8.    Once the  6KPM cards have been installed, the chassis top cover should be 

replaced by matching at the two front corners properly and slide in until it 

reaches the rear end and fit properly to match the holes. Make sure the chassis 

cover is aligned properly before securing the enclosure. Place the front panel 

part at the end by sliding in to the front side and secure it with 12 screws as 

being mentioned earlier. 

Reverse mount Model): The Reverse model require a LED Decal,  (for 

checking the speed, F/H, and activity status)   
 
3.5.3 

  To properly remove a 6KPM card from the 6K32 Managed Switch, follow the 

3 steps below.  

Step 1.  Remove chassis cover      See procedures in Section 3.5.1 above.