GarrettCom 6K16V Manual De Usuario

Magnum 6K16V Managed Fiber Switch         Installation and User Guide (06/04)

 

The 4-port @10Mb ST fiber modules behave the same as the 4@100Mb ST 

fiber modules except for the 10Mb speed. For ports numbering, ports 1, 2, 5, 6 are 
present, ports 3, 4. 7, 8 are not present.  There is also a similar 100Mb fiber SC module. 

The default setup on the 10Mb fiber module is half-duplex, which allows the 

Magnum 6K16V Switch to connect to any 10Mb hub or media converter or almost any 
other device with a 10Mb fiber Ethernet port. The default setting of the 100Mb module is 
full duplex. User mode-control per port through the MNS “port settings” software is the 
same as the other 6K16V modules.  

The fiber ports support fiber cabling distances according to the 10BASE-FL 

and 100BASE-FX standards, i.e., 2km distance for multi-mode fiber. (Single-mode for 
up to greater distance may be available as a special order, request quote). 

 

The Magnum 6K16V offered a wide option Gigabit speed with multiple choice 

for the modular slot. While up to two Gigabit modules (maxm.) can be configured in the 

modular slot. The Gigabit port option for the modular slot comes in couple of different 

configuration. The two Giga port has been offered as GBPM-2OTX (fiber or RJ-45), 

whereas the single Gigabit module comes in flavor of G+4(10/100 RJ-45 ports) or G+2 

(100Mb fiber ports) as shown below in the figure. 

 

 

 

 

                                                                   

                                                                                        

The 6K16V Modules provide a GBIC opening for insertion of industry-standard GBICs 

to provide Gigabit (Gb) media flexibility. GBIC models are available for both multi-

mode (550m) and single-mode (10, 25,40,70)km fiber options, and for Gigabit copper as 

well, with new models appearing often. 

 

 

 

 

 

  

  

1                                          5 

 

11

.

.