GarrettCom 6K16V Manual De Usuario

Magnum 6K16V Managed Fiber Switch         Installation and User Guide (06/04)

 

Note:  the modules used in the 6K16V vertical mount unit are similar to those 

used in rack-mount 6K units, except that the top LEDs are positioned for front viewing 

for the vertical-mount 6K16V model.  The modules have the letter”V” in the model 

numbers, but otherwise are the same.  In the Port Module materials below, all modules 

are referred to as “6KPM” for convenience in describing port module installation. 

Magnum 6K16V Switches are normally received from the factory with all 

required 6KPM modules installed. There may be situations where 6KPM cards need to 

be added or replaced.  In cases where additional 6KPM cards are needed, the faceplate 

for an available front-mounted slot must be removed. The following procedure describes 

this operation. 

Step 1.  Make sure the 6KPM Card package has all necessary accessories to install it 

properly. Each 6KPM Card package except the Gigabit, for field installation 

contains (Daughterboard (Bigger) and Granddaughter board (smaller), three 5/8  

stand offs for Granddaughter board, 6 standoff for daughter Board, nine  #4-40 

Pan-Head screws along with Front panel face plate package. The Front panel 

faceplate package includes 2 retainer brackets and four #2-56 flat head screws. 

module separately one by one to avoid the mixing. Do not change the Blue 

 

25

.

.