GarrettCom Magnum ST80 Manual De Usuario

Stackable Personal Hubs 

 Installation and User Guide   (04/01)

 
 

13

 

.

.

included in the stack, attach them in the same manner.  (The brackets and screws 

included with the bottom unit of the stack will 

not be used for stacking purposes.)      

 

Twisted Pair Segment Connections 

 

1.  Using standard 10BASE-T media, 

insert the male plug on one end of the network 

cable into one of the RJ-45 female ports on the 

Stackable Personal Hub.  Even though the hub's 

ports are of the shielded type, they will accept and operate properly with both shielded 

and unshielded type RJ-45 twisted pair wiring. 

 

2.  Connect the other end of 

each wiring cable to the applicable 

workstation or user device.  The port’s 

LINK LED illuminates when the 

connection is made on both ends of the 

wire, and when the DC power is on at 

each end, i.e., when the segment 

circuit is established and is ready to use. 

 

3. For the port 8 up-link feature, see 3.8. 

Connection 

 

Using the steps below as a guide, attach a new or existing 10BASE5 ThickNet drop-

cable directly to the AUI connector on the rear of the ST80 Personal Hub.  

1.  Plug the male end of the cable into the female AUI connector on the ST80. 

2.  Engage the AUI connector slide lock to insure maximum connectivity. 

3.  Connect the opposite end of the cable into a network AUI port.  (This could be a 

network backbone transceiver, a hub or fan-out with an AUI port, or an AUI Port Module in 

a concentrator.)