GarrettCom ES42 Manual De Usuario
ES42 Series Edge Switches
Installation and User Guide (05/05)
3.8.3
Connecting Fiber Optic SC-type, "Snap-In"
The following procedure applies to installations using SC-type fiber
connectors, i.e., using multi-mode SC and SC single-mode. While connecting
fiber media to SC connectors, simply snap on the two square male connectors
into the SC female jacks of the Fiber connector until it clicks and secures.
connectors, i.e., using multi-mode SC and SC single-mode. While connecting
fiber media to SC connectors, simply snap on the two square male connectors
into the SC female jacks of the Fiber connector until it clicks and secures.
3.8.4 Connecting
Single-Mode Fiber Optic
When using single-mode fiber cable, be sure to use single-mode fiber port
connectors. Single-mode fiber cable has a smaller diameter than multi-mode
fiber cable (9/125 microns for single-mode, 50/125 or 62.5/125 microns for
multi-mode where xx/xx are the diameters of the core and the core plus the
cladding respectively). Single-mode fiber allows full bandwidth at longer
distances, about 20Km with the multi-mode SC.
connectors. Single-mode fiber cable has a smaller diameter than multi-mode
fiber cable (9/125 microns for single-mode, 50/125 or 62.5/125 microns for
multi-mode where xx/xx are the diameters of the core and the core plus the
cladding respectively). Single-mode fiber allows full bandwidth at longer
distances, about 20Km with the multi-mode SC.
The same procedures as for multi-mode fiber apply to single-mode
fiber connectors. Follow the steps listed in Section 3.8.2 above.
fiber connectors. Follow the steps listed in Section 3.8.2 above.
52
www GarrettCom com
.
.